Sending a fax through Obi202?
fathom:
THANK YOU THANK YOU!!!!
SIP ALG was my problem too (after 4hrs of trying various settings).
Brilliant to bring the topic up and solving the problem.
I have mine as g711u and t38 , not sure which one was used
Will play around with other voip provider too (so far success with call centric, wanted to use the T38 feature...how do I know when T38 is being used?)
QBZappy:
fathom,
A mini how to written by Billt928:
Re: FAX T.38
http://www.obitalk.com/forum/index.php?topic=3997.msg28737#msg28737
fathom:
Thanks for the link.
I had to do some changes (trial and error because I would get a dial tone but it would not connect).
So now it's working: faxed from home (brother MFC-495W set at lower rate to obi202 via callcentric free outgoing per use service) to work (xmedius T.38 over ip fax company) and all 5 pages, including a PDF. Looks like it went through using the T.38
Duration totall was 225 (this is a snapshot midway)
Direction Outbound Outbound
RTP Transport UDP
Audio Codec tx=; rx=G711U
RTP Packetization (ms) tx=0; rx=20
RTP Packet Count tx=192; rx=252
RTP Byte Count tx=33024; rx=33384
Peer Clock Differential Rate 0 PPM
Packets In Jitter Buffer 0
Packets Out-Of-Order 0
Packets (10ms) Interpolated 5
Packets Late (Dropped) 2
Packets Lost 0
Packet Loss Rate 0 %
Packet Drop Rate 1 %
Jitter Buffer Length 110 ms
Received Interarrival Jitter 80 ms
DTMF Digits Received 0
Jitter Buffer Underruns 2
Jitter Buffer Overruns 0
Sequence number discontinuities 0
skew compensation 0 ms
send silence 0
jjtricket:
Audio Codec tx=; rx=G711U
fathom:
From billt928 post:
You can tell your using T38 under call status (it does not show T38) but this line will change
Call Status
Audio Codec = tx=G711U; rx=G711U
Will change to when sending
Audio Codec = tx=; rx=G711U
or
Audio Codec = tx=G711U; rx=
when receiving a fax
Navigation
[0] Message Index
[#] Next page
[*] Previous page