Swedish caller ID
Kacper:
Quote from: QBZappy on July 05, 2012, 09:46:45 am
Kacper,
I know there have been successful OBi implementations in Sweden. You may spend some moments searching the forum for others who have set it up in that environment.
By the way you have not mentioned the OBi model you are trying to set up.
PS
Just for fun, try different combinations of CallerIDMethod & CallerIDTrigger types. Otherwise I suggest you send Obihai support a quick email. I'm sure they must be taking note of configurations in different countries.
It's the Obi110. CallerIDTrigger is a strange function since setting it to anything else besides the default settings makes the phone connected to the OBI never ring.
Stewart:
Try setting CallerIDTrigger to After Polarity Reversal but also set IdlePolarity to Reverse.
If the phone still won't ring, report whether you get connected, if you answer when it should be ringing.
Also, what does Phone and Line Status show when the phone should be ringing?
QBZappy:
Kacper,
Note there are two CallerIDDetectMethod settings
Physical Interfaces
PHONE Port
LINE Port
Kacper:
I think it's some kind of bug. Most Swedish phones also support caller id via bell 202, so I tried it and boy did it work. Perhaps a bug in the firmware is rendering the OBI110 incapable of generating the correct DTMF tones.
QBZappy:
Kacper,
Yahoo its working. :D
A couple of OBi users located in Brazil mentioned on this forum that they had to select CallerIDMethod: DTMF (Finland, Sweden) for it to work there. Who knows. Now go out and enjoy a Carlsberg.
Navigation
[0] Message Index
[#] Next page
[*] Previous page