No GV Call PResentation on Obi device?
RonR:
Set:
System Management -> Auto Provisioning -> Method : Disabled
Every time you rebbot, your OBi is getting updated by settings on the OBiTALK Portal.
Disabling Auto Provisioning will stop that.
If you ever want to be controlled by the OBiTALK Portal again, simply set it back.
obitalker:
Re: Auto Provisioning
That worked. Now I can disable X_SkipCallScreening.
Thanks!
Dead_Cow:
It would be better if we could leave Auto provisioning on, and just set the parameters on the obihai portal. In fact, why have 2 places to control the device at all? I'm sure there's a reason.
srhuston:
Quote from: Dead_Cow on March 19, 2011, 06:21:10 am
It would be better if we could leave Auto provisioning on, and just set the parameters on the obihai portal. In fact, why have 2 places to control the device at all? I'm sure there's a reason.
I can't find the post now, but I believe it was mentioned that Obihai is working on a new portal that does just that - loads in *all* the values that can be set on the device, and lets you leave autoprovisioning turned on and select how complex you want the configuration interface to be (the current "easy" mode and a more advanced mode).
QBZappy:
Dead_Cow,
Hi
Having two ways to configure the OBi allows us to have the ability to configure the OBi remotely and directly on the OBi web unit. The OBi portal is designed with wizards that make it easier to configure your unit or your friend's unit. You can setup sip accounts from various VSP automatically, etc... This feature removes much of the mystery of configuring the unit.
All these configs can be accomplished manually on the OBi unit directly. This is a very good thing. We would not want to be dependent on the OBi servers. 100% of the setting can be done via the unit.
You are correct that it has been a cause for confusion. That is why there is a sticky suggesting to use the portal or web interface to configure the unit but not both.
Navigation
[0] Message Index
[*] Previous page