Callcentric and Google Voice Setup Guide (with CNAM)
BCloud:
This setup works for me: CID now displays names of the caller. However I'm receiving a stuttered ring when I make test calls from my cell phone.
Any Ideas why or how to fix?
BCloud:
I managed to figure it out. SP2 has a completely different ring profile and pattern than SP1 which my phyical cordless phone could not handle.
I simply swapped Callcentric to SP1 (for inbound calls, 911, CNAM), and GV to SP2 (for outbound, local number).
Problem solved. ;D
jimates:
Or you could have just changed the X_RingProfile for SP1 and SP2.
Voice Service -> SP1 Service -> SP1 Service -> X_RingProfile = A or B
I set both of mine to A, since my gogole voice calls on SP1 aren't delivered to the phone anymore.
CoalMinerRetired:
I realize I'm late to the party here. Can someone clarify a point on MWI and stutter dialtone, please?
If one does the setup scenario here with GV, CC and their CNAM, does that give up the ability to have th MWI and VMWI (stutter and light) activate based on unread VMs in GV's VM?
jimates:
I tested it once with my daughters Obi.
I changed the set up to use SP2 (Callcentric) and send SP1 (google voice calls) to nowhere {}.
I enabled the MW items on her Obi for SP1 (google voice), and left those for SP2 off.
I called her google voice number and left a message.
In a short while there was a blinking light on her phone and then the stutter dial tone when I took the phone off-hook.
Navigation
[0] Message Index
[#] Next page
[*] Previous page