Bridging and CallerID

<< < (2/3) > >>

QBZappy:
rsriram22,

Quote from: rsriram22 on July 13, 2012, 06:26:58 am

Thanks I will try this. Just so I understand this better, the SIP spoof (SIP->X_SpoofCallerID) needs to be checked on the sender obi (and on both of ITSP profiles), correct?


I got it to work on the OBion PC APP. In that setup the only place to enable that check mark was in the OBi making (forking) the call. If in doubt try all the possible combinations.

Edit:
You may need this. I am looking at my config above it seems to be missing the "ob" part.
{pp(ob290111222),ph}

yiannisc:
Hi,

first of all, thanks for the quick response.

You are telling to change things on the SP1. I do not use any SIP accounts. Only the Phone Line and the Obi Service. So, do I need to do something else?

CID propagation/forwarding never worked. I want to set it up now for the first time between the two Obi110s.

Thanks again,
Yiannis

QBZappy:
That was an example.

Try this on the OBi1: Replace 290111222 with your Obi 2 number
Physical Interfaces->LINE Port->InboundCallRoute = {pp(ob290111222),ph}

yiannisc:
Hi QBZappy,

thanks for your reply. I have that already and the calls are being forwarded to Obi2. The problem is that the CallerID is of the original caller is not shown at the Obi2.

Any other ideas?

Thanks again,
Yiannis

QBZappy:
yiannisc,

I just made a test call using POTS->OBi110->OBi100. CID from the POTS passed to my OBi100.

Navigation

[0] Message Index

[#] Next page

[*] Previous page