Obi202 Call Forward Doesn't Work
dial.tone:
I went to OBI Expert Configuration>Voice Service>SP1 and checked the box next to CallForwardUnconditionalEnable. I still only get a steady tome when I try to forward by dialing *72. No voice prompts asking for the number I want to forward to. Even tried rebooting the device by unplugging the power cord for half a minute and plugging it back in.
QBZappy:
dial.tone,
Quote from: dial.tone on July 14, 2012, 04:30:40 am
I went to OBI Expert Configuration>Voice Service>SP1 and checked the box next to CallForwardUnconditionalEnable. I still only get a steady tome when I try to forward by dialing *72. No voice prompts asking for the number I want to forward to. Even tried rebooting the device by unplugging the power cord for half a minute and plugging it back in.
I just tried it myself. I did hear the tone (No voice prompt), then typed in the telephone number+# I wanted to call forward to. You should then hear 3 short beeps confirming that the number was accepted. To test, look in the OBi unit or Expert in the CallForwardUnconditionalNumber=SP1(5145551212) section. You should see the number you just typed in show up in one of the boxes.
My problem now is when I press *73 Disable Call Forward All I get "there is no call route to complete your call" meassage from the OBiMAN recording.
dial.tone:
Quote from: QBZappy on July 14, 2012, 08:13:19 am
dial.tone,
I just tried it myself. I did hear the tone (No voice prompt), then typed in the telephone number+# I wanted to call forward to. You should then hear 3 short beeps confirming that the number was accepted. To test, look in the OBi unit or Expert in the CallForwardUnconditionalNumber=SP1(5145551212) section. You should see the number you just typed in show up in one of the boxes.
My problem now is when I press *73 Disable Call Forward All I get "there is no call route to complete your call" meassage from the OBiMAN recording.
Whew, that was a close call: I read your first paragraph and started to grab for the phone, anxious to try it; then my eyes scanned down to your second paragraph and I stopped midair! I sure don't want to get my phone stuck in forwarded mode and not be able to unforward it. Did you get yours unstuck yet?
QBZappy:
Yes, I had to go into the unit itself and put a check mark back in the OBi default.
Ostracus:
Quote from: QBZappy on July 14, 2012, 08:13:19 am
dial.tone,
Quote from: dial.tone on July 14, 2012, 04:30:40 am
I went to OBI Expert Configuration>Voice Service>SP1 and checked the box next to CallForwardUnconditionalEnable. I still only get a steady tome when I try to forward by dialing *72. No voice prompts asking for the number I want to forward to. Even tried rebooting the device by unplugging the power cord for half a minute and plugging it back in.
I just tried it myself. I did hear the tone (No voice prompt), then typed in the telephone number+# I wanted to call forward to. You should then hear 3 short beeps confirming that the number was accepted. To test, look in the OBi unit or Expert in the CallForwardUnconditionalNumber=SP1(5145551212) section. You should see the number you just typed in show up in one of the boxes.
My problem now is when I press *73 Disable Call Forward All I get "there is no call route to complete your call" meassage from the OBiMAN recording.
Odd, worked fine on my Obi202. What firmware is everyone using?
Navigation
[0] Message Index
[#] Next page
[*] Previous page