Date on device

(1/4) > >>

Lapog:
Hi,

New here...

I have OBi100. It is connected to a Panasonic KX-TG5632.

I have set the instrument date/time several times, but it always changes back to 01.01.2012, 12:00am. I believe this is to do with OBi100 setting. I am unable to figure out how to set correct date and time.

Any help is appreciated.

Thank you!

QBZappy:
Two places to check:

1) System Management->Network Settings->Time Service Settings->NTPServer1
=  Choose Default setting

2) System Management->Network Settings->Time Service Settings->LocalTimeZone
= Choose your location

More than likely you are making changes in the unit and the Expert tool in the OBi portal is configured to provision the settings to the unit (over ride the unit). Either make your changes in the portal or disable the auto provisioning setting in the OBi and make your changes there.

Read this to understand
    
Managing Your OBi Device Configuration: OBiTALK or OBi Web Page but NOT Both
http://www.obitalk.com/forum/index.php?topic=92.0

Lapog:
Quote from: QBZappy on July 18, 2012, 12:23:36 pm

Two places to check:

1) System Management->Network Settings->Time Service Settings->NTPServer1
=  Choose Default setting

2) System Management->Network Settings->Time Service Settings->LocalTimeZone
= Choose your location

More than likely you are making changes in the unit and the Expert tool in the OBi portal is configured to provision the settings to the unit (over ride the unit). Either make your changes in the portal or disable the auto provisioning setting in the OBi and make your changes there.

Read this to understand
    
Managing Your OBi Device Configuration: OBiTALK or OBi Web Page but NOT Both
http://www.obitalk.com/forum/index.php?topic=92.0


Thank you for a quick reply.

I think I've already tried those setting, without results.

I am unable to figure out how to use the 'attach' function in the forum (says "uploader full, contact admin" for a 55KB file!). Anyway, the NTPServer1 is set to default, and LocalTimeZone is 'Central'.

Yes, I read the document and I familiarized myself with 'expert settings'. May be I am missing something?

Anyway, it also says "If you disable auto-provisioning, you will not be able to manage your OBi devices remotely." I do wish to retain remote configuration ability.


PS: Hope I find a better solution. For now, I have disabled 'Autoprovisioning' and reset the date on the device. Hope this works.

QBZappy:
Lapog,

Are you using the OBiTALK portal or the unit web page to set the configuration? (You did not mention it yet)

Lapog:
Quote from: QBZappy on July 18, 2012, 01:21:32 pm

Lapog,

Are you using the OBiTALK portal or the unit web page to set the configuration? (You did not mention it yet)


Apologies for that. I am using the unit-web page for configuration.

BTW, it failed again. As soon as the first call came, the instrument (Panasonic) date/time was reset. :(

Navigation

[0] Message Index

[#] Next page