Make this default setting: OBi's Ethernet ports to 100 mb/s full duplex

<< < (3/3)

JohnBowler:
Quote from: QBZappy on August 01, 2012, 07:05:39 pm

Not making this default seems to cause more problems than anything else.


This doesn't apply to the OBi202, at least not the 'lan' port.  I have option 27 set to 0 and the LAN port is connected to my switch at 100Mbs full duplex.

(I am running the new version 3375 of the software, the one with the bluetooth support, but I'm pretty sure it was 100Mbps on version 3184 as well.)

John Bowler <jbowler@acm.org>

bathynomus:
Quote

Switching your OBi's Ethernet ports to 100 mb/s full duplex:
1. Dial *** 0
2. Enter option 27 and press #
3. Press 1 to set a new value
4. Enter a value of 1 and press #
5. Press 1 to confirm/save
6. Hang up
7. Wait for the OBi to reboot


Confirm settings:
Quote

How to verify the current setting of the OBi's ethernet ports 10 or 100 mb/s full duplex:
1. Dial *** 0
2. Enter option 27 and press #

At this point the OBiMAN will read back the current value:
0= 10 mb/s
1= 100 mb/s

My folks own the Obi202 and I think this may have fixed their problem as well. Perhaps this should be a sticky topic on the forum.

Navigation

[0] Message Index

[*] Previous page