Dialing *75 from your OBi, speed dial entry in VoIP.ms phone book

(1/4) > >>

OBiSupport:
A service provider may use any digit combination for your configuration of speed dial entry.

Service Provider: VoIP.ms has reserved speed dial numbers: *7501 - *7599

To be able to use the VoIP.ms speed dials in your OBi, you need to do two things:

1. Delete or modify the Star Code entry(ies) that has *75.
In OBi's default configuration, you will see in both "Star Code Profile A" and "Star Code Profile B", that *75 is referenced as Code 22 for (Check Speed Dial).

2. Add *75xx to your SP DigitMap.  By taking out *75 in the Star code profile(s), you won't be able to dial *75 until you add *75xx to your DigitMap, so it looks like (*75xx|1xx......etc....).

OBi-Guru:
We made changes to the wizard configurator specifically to VoIP.ms to allow *75 dialing not to conflict with other star-codes as described above.

hillandfate:
To be able to use the VoIP.ms speed dials in your OBi

dani:
I've been trying to setup this, but it's proving more difficult than I imagined.
I keep getting a busy tone as soon as I dial *75.
Dialing **2*75xx works fine.

This is my current setup:
Star Code Profile A > Code22 > EMPTY (all other codes are DEFAULT, nothing else has *75)

Star Code Profile B > Code22 > EMPTY (all other codes are DEFAULT, nothing else has *75)

Physical Interfaces -> PHONE Port -> PrimaryLine : Default (PSTN)

Physical Interfaces -> PHONE Port -> OutboundCallRoute:
{([1-9]x?*(Mpli)):pp},{(<#:>|911):li},{**0:aa},{(*75xx):sp2},{***:aa2},{(<**1:>(Msp1)):sp1},{(<**2:>(Msp2)):sp2(8885551212>$2)},{(<**8:>(Mli)):li},{(<**9:>(Mpp)):pp},{(Mpli):pli}

Service Providers -> ITSP Profile A -> General -> DigitMap: (Google Voice)
Default

Service Providers -> ITSP Profile B -> General -> DigitMap: (voip.ms SIP)
(*75xx|*xx|1xxxxxxxxxx|<1>[2-9]xxxxxxxxx|011xx.|xx.|(Mipd)|[^*]@@.)

Physical Interfaces -> LINE Port -> DigitMap:
([2-9]11S0|[2-9]xxxxxx|[2-9]xxxxxxxxx|18(00|88|77|66|55)xxxxxxx|<1>8(00|88|77|66|55)xxxxxxx| <**1>1[2-9]xxxxxxxxx|<**2>011xx.|<**2>10xx.)

Any help would be much appreciated.

ianobi:
dani,

Service Providers -> ITSP Profile B -> General -> DigitMap: (voip.ms SIP)
(*75xx|*xx|1xxxxxxxxxx|<1>[2-9]xxxxxxxxx|011xx.|xx.|(Mipd)|[^*]@@.)

This has put *75xx into Msp2. Therefore it is already referenced in Physical Interfaces -> PHONE Port -> OutboundCallRoute. The rule {(*75xx):sp2} is not needed there.

It is generally thought best to leave PhonePort DigitMap and OutboundCallRoute at default. Then do any routing in the trunk digit maps. The following looks a bit out of place in the PhonePort OutBoundCallRoute:

{(<**2:>(Msp2)):sp2(8885551212>$2)} but then I don't know what it is trying to achieve.

Navigation

[0] Message Index

[#] Next page