New firmware causing dropped calls.

<< < (2/3) > >>

M105:
Yeah, that is what I downloaded but the Obi says 2711 after installing that file.
---
You are also correct about the latest being 2719.  So I just downloaded the actual file 1-3-0-2711.fw and installed it.  I will give it a run and see if it corrects the issue.  Thanks for the heads-up!

rfc1918:
I have been experiencing dropped calls with my Obi110 and GV.  The direction of the call does not matter.  At first, it was dropping the call around 10-15 minutes although it happened again today at 5 minutes.  I am 7 days into the problem.  I don't think the call is being dropped but rather one-way audio where I cannot hear anything.  I upgraded to 2719 around the same time the problem started but it sounds like that is a coincidence.  

When I tested last week, I could not keep a Obi110 + GV call up with two-way audio for longer than 15 minutes.  I signed into Google Talk via my Talkatone iPad app on wi-fi and was able to keep the call up for 15+ minutes.  Although, I believe Talkatone proxies the media so they can do transcoding for a different codec to the client.    

PS - I did a complete configuration reset to make sure there wasn't something wrong with the config.

M105:
Going back to 2711 greatly improved my dropped call problems.  Wish I could undo the remote unit I updated...

Where is Obi support?  They have not even documented the new update in the forum...  Is the 100/110 now a red headed stepchild?

Steve34:
I am not sure the problem is with the new firmware. It may be with Google voice itself. I too, have experienced dropped calls lately and I have two setups. My original setup uses a Linksys PAP2T with sipsorcery and Sipgate. I have lately been experiencing dropped calls using both my OBI100 and my original setup. So, the problem appears to be with Google voice unless both systems are malfunctioning simultaneously.

Obviously, this is a major problem that appears difficult to resolve. If someone has a solution or an explanation that accounts for both systems malfunctioning I would very much like to hear it.

Update: I just updated to new firmware and will see if problem solved.

M105:
I installed the latest firmware as well.  I wish Obi would tell us what they are doing with the 100/110.
---
My only complaint on the obi/GV solution is the dropped call problems that seem to come and go.  Wherever the issue is originating, they need to work on improving.

Navigation

[0] Message Index

[#] Next page

[*] Previous page