Two Different Google Voice Accounts
whitestar:
Thanks guys. I'll update when I get home tonight. Is there a page where I can download old firmwares in case I need to restore an old version? I looked around but I couldn't find one.
RonR:
The only old one I see is 2283. I seriously doubt you'd have a need to regress from 2384, but if you do, I've kept every publicly posted version.
whitestar:
well i upgraded the firmware to the latest (##89 if I remember correctly) and I get the same problem. So, to clarify what is happening:
The light for the 2nd line never even lights up.
When I connect a phone I hear no dial tone.
When I dial a number, either just a 10 digit number or **2 beforehand, I hear absolutely nothing.
When I dial *** to get the menu, nothing happens.
The web portal at the Obihai website says I am connected. Just to try something, I input the wrong password and it said "Backing Off (0s):Authentication error" so I assume that it is connecting to GV with the correct password input.
RonR:
Quote from: whitestar on June 20, 2011, 07:35:42 pm
well i upgraded the firmware to the latest (##89 if I remember correctly) and I get the same problem.
I would recommend 2384 as 2289 has some documented problems.
Quote from: whitestar on June 20, 2011, 07:35:42 pm
The light for the 2nd line never even lights up.
What light for a second line are you talking about? If this is something on the OBiTALK web site, disregard my question.
Quote from: whitestar on June 20, 2011, 07:35:42 pm
When I connect a phone I hear no dial tone.
When I dial a number, either just a 10 digit number or **2 beforehand, I hear absolutely nothing.
When I dial *** to get the menu, nothing happens.
An OBi straight out of the box still at factory defaults should give you a dialtone on the telephone connected to PHONE Port. No other connections or configuration is required. You should be able to dial *** and get to the configuration menu or **0 and get the OBi attendant. If this isn't happening, you have a defective OBi or a defective telephone.
whitestar:
Ah, I was talking about the "Line, Telco" input on the Obi110. There is a light that I assume lights up when its configured and connected. I'm assuming thats line 2?
Or are both Line 1 and Line 2 connected to the "Phone" jack? That's something I didn't consider until just now. How does one use the line port then? I even tried connecting a dial up modem and nothing happened.
Also, the unit I got looks different than all the images here on Obihai and Amazon. There are large colorful symbols on the unit, which is probably just decorative, but maybe I got a slightly newer model as I just ordered it last week?
[UPDATE] ah, I just tried a **2 dial with my phone connected to the "Phone" port and I could see the second google voice number show up. I've gotten so used to a Linksys PAP2 with 2 ports for 2 lines.
Navigation
[0] Message Index
[#] Next page
[*] Previous page