Solved with 1.2.0 (Build: 2102) Obi110 Resetting on its own?

<< < (2/2)

moku160:
Thank you.
That may not have solved my problems but at least I understand some of it a little better now.

It seems that the only way I can dial out with my ooma is dialing '#' prior to the number
Is there anyway I could automate '#' so I dont have to enter it everytime I want to dial out?
I doubt it but is there a way to dial using GV but have my Ooma number caller id displayed?

moku160:
I dont know if anyone read this, but I figured I would update it in case.

Updating with newest firmware on April 1st, solved my issue with not being able to dial out with PSTN, ooma.
My other issue with gizmo project is moot because gizmo no longer is in operation.  I have ordered another Japan DID number with DIDWW and when I get the SIP info I will be setting it up and hopefully it will work with the new firmware where gizmo didnt.

oleg:
Quote from: moku160 on March 25, 2011, 12:18:27 pm

Is there anyway I could automate '#' so I dont have to enter it everytime I want to dial out?


I would try configuring "PHONE Port"->"PrimaryLine" as "PSTN".
Sorry, I can't verify it (don't have PSTN)

freewilly:
I have the exact setup, and facing the same problem.

I am able to dial out from ooma, I need dial 1+[area code]+ number, even if the area code is same as my ooma phone number.

I don't have to dial area code (if same) when I connect my phone to ooma directly.

I've tested using Obi110 to route my call through ooma without area code, and it worked.

Setups:

Land phone, with number: 1234567
Cell phone, with number: 2234567

Obi110, with SP1 and ooma
Inbound Settings -> ITSP InboundCallRoute {(x.1234567):li(2234567)}

I used phone(1234567) to call SP1, I received call from ooma at phone(2234567)

It showed Obi100 would be able to dial out from ooma without need of 1+area code internally

But the cause of reset, I suspect in the setting of "Phone OutboundCallRoute".

Can anyone help?

Thanks

freewilly:
I am able to dial out from ooma without dial 1+area code.

I have 626 area code.


Physical Interfaces
   LINE Port
      DigitMap
         (<1626>[2-9]xxxxxx|xxxxxxxS4|1xxxxxxxxxx|xx.)

Navigation

[0] Message Index

[*] Previous page