Obi 110 UK Emergency 999 configuration
ianobi:
I’m assuming that Localphone accept numbers in standard UK format. I don’t use them so I cannot confirm that.
First ensure this is set:
Physical Interfaces -> PHONE Port -> PrimaryLine : SP2 Service
If that’s ok then:
Service Providers -> ITSP Profile B -> General -> DigitMap:
(<0118>xxxxxxxS4|0[1-9]xxxxxxxxxS0|00xx.|xx.|(Mipd)|[^*]@@.'@'@@.)
Explanation:
<0118>xxxxxxxS4 seven digit number dialled, Obi waits four seconds to see if you are dialling more digits. If no more digits received, Obi prepends 0118 and send out to sp2. If you don't need 0118 to be prepended, then omit <0118>.
0[1-9]xxxxxxxxxS0 any eleven digit number starting with 0 but not 00 sent out to sp2 with no delay.
00xx. any number any length starting 00 will be sent out to sp2, but there will be a ten seconds delay while Obi waits to see if you have finished dialling.
xx. catch all rule. This is for anything that does not fit the above. Numbers will be sent out on sp2 after a ten second delay. I don’t like this rule much as it can show confusing results. I put it in to catch maybe 0800 numbers etc. Also if it is not here, then the xx. rules in the other digit maps will pick up non-matched numbers and send them out on sp1 or line.
(Mipd)|[^*]@@.'@'@@. These are for sip uri dialling (someone@somewhere format). Omit them if you don’t want that or if Localphone does not support it.
The Obi is very flexible and very configurable. If you ask three people on this forum to give you the best digit map, then you will probably get three different answers :)
Let us know how you get on.
Navigation
[0] Message Index
[*] Previous page