obi110 line port has {aa} inbound route and the phone rings?

(1/3) > >>

rsriram22:
subject says it all - i have just {aa} in my inbound route under LINE on obi110 and the phone rings.. How is that possible?

Just to make sure, i looked up status-> phone status and lastcallerinfo for both line and port have the same number..

i am sort of lost here.. how is this possible?

thanks.

Huib:
What does the call history say? It could go to aa and then the caller presses 1 and is connected to your phone.

rsriram22:
i cannot access the history since i control devices from the obitalk portal (and not locally) as the device is at a remote location

Is it possible that aa automatically assumes 1 if no choice is clicked ( i dont remember clicking anything when aa answered..)

QBZappy:
Quote from: rsriram22 on September 20, 2012, 08:01:42 am

Is it possible that aa automatically assumes 1 if no choice is clicked ( i dont remember clicking anything when aa answered..)


Yes the OBi repeats the message 3 tries, then it rings the phone.

jimates:
Quote from: QBZappy on September 20, 2012, 08:04:18 am

Quote from: rsriram22 on September 20, 2012, 08:01:42 am

Is it possible that aa automatically assumes 1 if no choice is clicked ( i dont remember clicking anything when aa answered..)


Yes the OBi repeats the message 3 tries, then it rings the phone.

Although it is not supposed to, there was also a previous report of this behavior. After giving the announcement 3 times, the Obi is supposed to just drop the call. Perhaps a bug that should be submited to support.

Navigation

[0] Message Index

[#] Next page