'pooling' SPs of different obi's

<< < (2/3) > >>

rsriram22:
yep, that's the idea, jimates.. good to know that it is feasible...i will have to play around a bit to be able to achieve this I suppose..

come to think of it, single stage dialing may help me - some thing like following to dial out of SP2 on obi '3':

3 **2 <the actual international dialing # goes here>

am in the going the right path or should i setup a gateway?(how do i do that?)

jimates:
What you want will work if you want to depend on the Obitalk Service and with single stage dialing through any Obi trunk set up.

When dialing 3*911 from your Obi, the remote Obi will dial 911 using SP2 (with the speed dial of the remote Obi being 3) as long as all the related digit maps and outbound call routes accept "911" as valid.

I have been on a mission to buy my kids 2 iPhone 4's on ebay for the last few days. Now that I have that out of the way I will experiment with it.

jimates:
Working on it.
I successfully set a remote Obi to dial an alternate number when I press 5*911 from my main Obi.

I have to get the remote Obi's Obitalk service to pass the exact 9 1 1 through.

rsriram22:
in the case of 911,ideally, i just key in just 911 on the local obi and it goes out through SP2 (say, anveo) on remote obi and when it goes to 911, my local phone # is sent so that they have the phone # and also related smart911.com info as well.

basically, the whole process would be transparent to the caller.

thanks again for taking time out in helping/guiding me..

jimates:
One problem might be the possibility of call back. If the 911 is placed with Anveo, your number won't be displayed. The displayed number is regulated by Anveo.

I originally thought that using Anveo I could designate which number was displayed, but a discussion on this forum said other wise. So I dumped Anveo.

Navigation

[0] Message Index

[#] Next page

[*] Previous page