Call forward to mutiple numbers?
ccchih:
Almost there!
After applying the new routing settings, calls from all others with ring 12341111111 using SP1 and 12342222222 using SP2 AT THE SAME TIME. There is no 4 seconds delay on SP2.
RonR:
It appeared to work here. From the 1.3 release notes:
- All InboundCallRoute and OutboundCallRoute syntax will take a ";d=[delay-in-seconds]" parameter after the number to call from the specified trunk, and to insert a delay before the trunk makes the call. For example, SP1(18002211212;d=3) tells the OBi to call the number from SP1 after a 3-second delay.
RonR:
I just tested it again and the delay is there.
RonR:
It does not appear to work with TGx or VGx.
I tested it with SP1 and SP2. Presumably, it also works with PP and LI.
ccchih:
After reading the release note, I did some more tests and yes, you are right. The new delay function is working perfectly on SP1 and SP2.
Unfortunately, I need the delay on PH1. Is there anyway I can change the settings to get it work?
Basically, I want to route all the incoming calls to an IVR through SP2, so ring the IVR using SP2 at the beginning. If somehow the IVR is down or busy, then ring the analog phone connected to OBi110 in the office.
Navigation
[0] Message Index
[#] Next page
[*] Previous page