CALL HISTORY (HOW DO I FIND IT?)

<< < (2/2)

Ostracus:
Quote

Additional Configuration Options Available with the OBi IVR after Pressing * * * 0:

Selection

Note: Always Press “#” After Entering Selection
   

Announcement
   

What Can You Do?

                30
   

Enable Web Management Access from WAN port

The current value will be read back.   (Effective in Router mode only)

0: Disable Access from WAN

1: Enable Access from WAN
   

Press 1 to enter a new value.

Press 2 to set the default value.

Press 0 to repeat the information.

Press # to enter another configuration selection.

BearJerCares:
I am having exactly the same issue in which the IP address of the Obi obtained by ***1 is not giving me the correct IP to enter the Obi Wan Portal (or whatever it is properly called) through http://192.168.0.128.  Any suggestions?  I'm trying to get into the Obi's call history because Callcentric is not sending me the NAME for incoming caller ID and they said to take a look in the Obi to see if both name and number are there.  Clear as mud?  I've been trying to figure out the problem for days now.  Thanks!

Shale:
Quote from: QBZappy on October 19, 2012, 08:12:24 am

RandyErie,

If this is the first time that you try the unit web interface you need to key in some digits on the handset to allow it. At the moment I don't remember what it is. You can look it up in the admin guide.


Step 2 in this:
To check the call history log:

1.  If you do not know the IP address of your OBi, find IP address:
from your phone dial ***1 and listen for the IP address.  Write it
down.

2. Enable web access from the WAN for your OBi:
Let a comma represent a pause.
 dial ***0,30#, 1, 1
Your OBi should read your current IP number to you. It is often
192.168.__.__ or 10.0.__/.___ where __ represents some numbers. Write
that down.

3. Enter the IP address that you wrote down into the address box on your
browser. If you don't know what a browser is, that means Internet Explorer,
Chrome or Safari. It could  also mean Firefox,  etc.

Be prepared to enter the password for your OBi. The username is admin.

4. On the left, click Status -> Call History.

carl:
It shows only 50 calls. Did not that used to be like 200?

Navigation

[0] Message Index

[*] Previous page