How Do I Bridge Two SIP Service Provders with the OBi?

<< < (2/2)

umesh:
Is there any way I can route the outbound call on any of the Gateways? If so how?

What I want is I call SP1(google voice) and AA routes the call on the say Gateway1. I also observed that when calls on SP1 and SP2 are bridged the codec issue comes up. GV uses G711 and my other service prov uses G729(strictly). When the calls are bridge I can't hear from other party.

Thanks,

obi-support2:
umesh,

You can reference to gateways using VG1, VG2, ..., VG8 in OutboundCallRoute of the AA, the same way you reference SP1, and SP2. You might need to use the Expert Configuration page on the OBITALK portal.

I would recommend you to test this on the PHONE Port first, and make sure you can route phone calls to the gateway, by modifying the PHONE Port's OutboundCallRoute.

Google Voice does not support g729; so bridging will not work with your SP1/SP2 if they only support g729. You must force the SP1/SP2 to use g711 if you have to bridge it with GV.

Navigation

[0] Message Index

[*] Previous page