PSTN Disconnect Detection issue (Attached disconnect tone)

<< < (2/2)

Shashank:
I strongly feel that Obi is unable to detect the Disconnect Tone. Because when the caller ends the call, i'm continue to hear the beep-beep-beep tone...that means Obi is unable to understand that the tone is being sent by the LINE/GSM Gateway to indicate that the caller has disconnected the call and so the entire call circuit should be close.

I feel this problem will be solved if the correct parameters can be found out from the disconnect tone that i uploaded...

Shashank:
SUCCESS!!

I referred to the user manual of my GSM Gateway(SIMADO GFXD1111s) and changed the values to:
400-18;30;(.25+.25)

And voila! The call gets disconnected after 6 sec after the caller ends! Million times better than the earlier 2 min delay! It would be awesome if its less than 6 sec though (yeah greedy ;) )

Navigation

[0] Message Index

[*] Previous page