Is it possible to use an ATA to connect to Obi110?

<< < (2/2)

oleg:
Quote from: JohnLennon on March 23, 2011, 12:30:26 pm

...ATA to ATA IP dialing is possible, I'm wondering how to do the same ATA to Obi.


If one of two Obi110 lines (ITSP A / sp1 or ITSP A / sp2) is configured for SIP signaling - setup should not differ from ATA to ATA. I used direct dialing, with no third party (except DNS).
I did the following:
- have dynamic DNS or similar (unless destination has fixed IP)
- have signalling port on firewall (NAT) mapped to OBi device - that's X_UserAgentPort in OBi
- know user name (that's AuthUserName in OBi)
ATA should dial SIP URI in form "AuthUserName@dynamic.host.name:X_UserAgentPort".
You may use dial plan or speed dial in ATA or even setup hotline.
Here is the sample of PAP2 Dial Plan:
Code:

...|<#4:123456@friend.host.net:5061>|...
dialing "#4" connects to 123456@friend.host.net:5061.

JohnLennon:
Thank you Oleg, this is exactly what I was looking for!  :D

majed@adwani.com:
Quote from: oleg on March 23, 2011, 09:39:19 pm

Quote from: JohnLennon on March 23, 2011, 12:30:26 pm

...ATA to ATA IP dialing is possible, I'm wondering how to do the same ATA to Obi.


If one of two Obi110 lines (ITSP A / sp1 or ITSP A / sp2) is configured for SIP signaling - setup should not differ from ATA to ATA. I used direct dialing, with no third party (except DNS).
I did the following:
- have dynamic DNS or similar (unless destination has fixed IP)
- have signalling port on firewall (NAT) mapped to OBi device - that's X_UserAgentPort in OBi
- know user name (that's AuthUserName in OBi)
ATA should dial SIP URI in form "AuthUserName@dynamic.host.name:X_UserAgentPort".
You may use dial plan or speed dial in ATA or even setup hotline.
Here is the sample of PAP2 Dial Plan:
Code:

...|<#4:123456@friend.host.net:5061>|...
dialing "#4" connects to 123456@friend.host.net:5061.




Dear Oleg,

Thanks for this info which is also exactly what i'm looking for. I'd appreciate it if you could elaborate more as i'm new to setting up a SIP VOIP device.

I have setup SP1 as Google Voice, should I do the above setup for SP2 to enable ip dialing on my pstn line?
Can you give an example of the signaling port on the firewall? is it port 5060 for example?
Know the user name - do I assign a username in the client and obi
what dialing app should I use on the iPhone?

I'd appreciate your response.

Regards,

Navigation

[0] Message Index

[*] Previous page