Using Voice gateways - am I on the right track

(1/2) > >>

FreddyK:
OK, I am about 4 months into using my Obi100 and all is going smoothly. I am set up with google voice (sp1) and freephoneline (sp2). Outgoing calls go through sp2. If they are not free, I dial **1 and use google voice for outgoing. I also have a voip.ms number (I ported my landline number over). It is permanently call forwarded to my freephoneline number. I would like to occasionally place an outgoing call through the voip.ms number. Is this what a gateway is for? If so, some searching brought me to this. Am I on the right track? (I have edited this)

To begin, you'll need to make a couple of additions to your PHONE Port DigitMap and PHONE Port OutboundCallRoute to add support for the new dialing prefixes:


Phone Port DigitMap:

|**1(Msp1)|**2(Msp2)|**3(Mvg3)|**8(Mli)|**9(Mpp)|

PHONE Port OutboundCallRoute:

{(<**1:>(Msp1)):sp1},{(<**2:>(Msp2)):sp2},{(<**3:>(Mvg3)):vg3},{(<**8:>(Mli)):li},{(<**9:>(Mpp)):pp},{(Mpli):pli}


This creates the following associations:

**3 -> Voice Gateway3 (VG3)


Now, let's set up additional VoIP providers on Voice Gateway3

Voice Gateway3 will be used with Whistlephone:

Name : Voip.ms
AccessNumber : SP2(proxy.voip.ms) (I am guessing here)
DigitMap : (Mste)
AuthUserID : your_voip.ms_user_id
AuthPassword : your_voip.ms_password


Not sure about this part
And finally, let's configure the User Defined DigitMap referenced in Voice Gateway3:

Label : ste
DigitMap : (1xxxxxxxxxx|<1>[2-9]xxxxxxxxx|<1aaa>xxxxxxx|011xx.|(Mipd)|[^*]@@.'@'@@.)

where aaa is your local area code.


Following a reboot, the OBi should be ready to use its new capabilities.

Dialing **3 + number should place a voip.ms call.


Any help would be appreciated! Thanks.

ianobi:
The DigitMaps etc look ok. The only question is does voip.ms support calling with no registration? I'm not a voip.ms user, so maybe someone who is might answer that.

You could just try and see what happens  :)

FreddyK:
Thanks, I am trying, to try. ;D I am not able to click on the enable "button". It is shaded. How do I enable a gateway? (through expert configuration). I am a noob. Hopefully I am not missing something obvious!

ianobi:
Enable is the default setting, no need to change it. Yes, it does seem odd!

FreddyK:
OK, but I am unable to enter anything into the fields  ???

Navigation

[0] Message Index

[#] Next page