OBi Expert Configuration (Introduction)
DaveSin:
After further testing, it appears the OBiTALK Web Portal setting relating to "DSCPMark" has being decoupled from the value on the Device Web Page (OBi Unit). With the latest Firmware, "DSCPMark" requires a value [0 - 63] and will not take any "value" in the form of "0x68" or "0xb8"
"DSCPMark" on the Device seems to default to 26 and 46 for the SIP and RPT respectively. So, this is not a corrupt value issue.
Quote from: QBZappy on October 25, 2011, 10:17:18 pm
This might have already been noticed. I'm seeing what seems to be some corrupt values in the Expert configuration page as compared to my OBi110 unit in both of these places:
Service Providers->ITSP Profile A/B->SIP
Service Providers->ITSP Profile A/B->RTP
DSCPMark=0x68 (Expert) ??
DSCPMark="XX" digit (OBi unit)
kasra:
Hi
i just got one of those obi 100 and connected to the router when i pick up the phone and dial **9 222 222 222 i can hear the operator voice and every thing looks OK but when i try to ad the device and even dial the code that obi add device page give me i can hear it says the number has been send to the server but it shows it fails to add the device is there any body can help me please and i was thinking is there any reset button
ProfTech:
I've been learning how to use the Expert mode & Portal and discovered a couple of things the hard way. When you make a change in one of the screens and click "submit" at the bottom of the page, the Obi normally reboots itself within 60 seconds or so. So after you click submit, WAIT about 5 minutes before making a change on a new page and clicking submit again! You must give the unit time to reboot and settle before clicking submit again. If you go too fast, the unit can become corrupted. My unit did not brick but went into a rolling reboot and I had to reset to factory defaults and start all over.
2nd, As far as I've been able to tell "importing" a config into the expert mode doesn't work. I tried it 2 or 3 times and after I performed the import all of the critical fields were still blank in the expert screens. So I had to go through all of the screens by hand and enter them anyway. If I'm doing something wrong I would be glad to hear about it.
Corollace:
Quote from: ProfTech on December 02, 2011, 02:29:36 pm
I've been learning how to use the Expert mode & Portal and discovered a couple of things the hard way. When you make a change in one of the screens and click "submit" at the bottom of the page, the Obi normally reboots itself within 60 seconds or so.
Yes, this is one thing annoying. I am afraid that the unit might be failed if there are too many rebooting. Would you (OBi) fix this in the future please?
ibotalk:
so i dont get how to make change on the web portal---nothing in the intro i could understand explained how to do that.
everything seems locked in the default stteints
can you help
thanks
Navigation
[0] Message Index
[#] Next page
[*] Previous page