Obi and Google Voice...Step-By-Step from the Beginning for Beginners

<< < (2/2)

welkiner:
Quote from: VOIPisGreat on November 30, 2012, 05:31:23 pm

Any reason why you opt not to use obion?


I read that Obion would not integrate with the native dialler, so I opted to try GrooVeIP first.  My primary goal was to get gv working to and from all my phones.  This was the first method I tried and everything is working great.

Any reason why I should have opted to use obion? 

dzblue:
Quote from: VOIPisGreat on November 30, 2012, 05:31:23 pm

Any reason why you opt not to use obion?


Aside from not integrated with Android's native dialer, I think ObiOn has to send voice traffic to your physical Obi device which is acting as bridge. Therefore, if you are outside of your subnet or local network, the traffic would needlessly traverse a lot more and possibly getting congested (affecting voice quality) before reaching GV.

Khoj:
Welkiner,

This is great. Followed your instructions and got GrooveIP working successfully.

But I am not having luck setting my 2nd Google Voice account. After making sure SP1 (1st GV account) + SP2 (Callcentric account) working, I configured SP3 for 2nd GV account and here is how the routing looks:

Phone Port Configuration Summary
                                                              Phone 1          Phone 2
Primary Line for Outgoing Calls Route to:   SP3                SP3
Phone Rings on Incoming Calls from:         SP1,SP2,SP3   SP2
Voicemail Notification Alert from:               SP1,SP2,SP3   SP2
Emergency Service Call Routes to:             SP2                SP2

I want to connect only one phone on "Phone 1" line and want to receive and place calls for both GV accounts from Phone 1. I want 2nd GV (SP3) to be the primary (default) line for placing calls and want to use **1 + number to call out from the 1st GV (SP1).

But incoming calls for 2nd GV number aren't ringing at OBi202 and goes to 2nd GV voicemail. Also, whenever I call out (without **1 or **3), caller ID on receiving end shows 1st GV number. And if I use **3 + number, it then shows my 2nd GV number.

Can you (or anyone else) suggest what might be causing 2nd GV number not ringing at OBi202 and also why it's still using SP1 as the default line to call out?

Thanks

Navigation

[0] Message Index

[*] Previous page