dialing #211# from remote obi

<< < (4/6) > >>

ianobi:
What is Call History showing?

Meanwhile, I will set up same test here.

denon321:
Hi here is the call history from OBI A110 the dialing obi:
Call 1   12/04/2012    06:34:14   
Terminal ID   PHONE1                           OBiTALK1
Peer Name      
Peer Number   **9ob200xxxxxx           ob200xxxxxx
Direction   Outbound                           Outbound
06:34:14   New Call   
06:34:21                                      Call Connected
06:34:43   End Call   

ianobi:
I should have listened to myself! From reply #2:

Quote
In some OBis getting the first # into a number would also be a problem.

The first # in your OBi110 connects the Phone Port direct to Line, so the OBi only sees # other digits are dialled on your PSTN line. This is due to <#:> in your Phone Port OutboundCallRoute.

Would you be OK dialling 211 and #211# being sent to line? If so, then this works - I have tested it!

(<#>211<#>|#211#|xxxxxxxS4|1xxxxxxxxxx|xx.)

denon321:
No do not mind at all; newbie question :
do i put (<#>211<#>|#211#|xxxxxxxS4|1xxxxxxxxxx|xx.)
on obi A and obi B? or only one?
thanks

ianobi:
This question is getting a bit scarey now  :o

Do you wish to dial 211 into OBi110A and have #211# come out of OBi110B Line Port to PSTN? I assume that the transfer will be via the OBiTALK network? If so, then I will need to know:

OBi110A > Physical Interfaces -> PHONE Port -> PrimaryLine : (PSTN is default)

OBi110B > Physical Interfaces -> PHONE Port -> PrimaryLine : (PSTN is default)

OBi110B > Voice Service > OBiTALK Service > InboundCallRoute: (ph is default)

Have I understood the question?

Navigation

[0] Message Index

[#] Next page

[*] Previous page