Routing through Freeswitch to record calls
v.2geofs:
Hi. We have the OBI110 in our office and are trying to configure it to port through freeswitch for recording. I have run into a serious snag. We've managed to use a gateway (vg1) to route LN1 to Freeswitch, then Freeswitch will setup recording and bridge the call back to SP2 where the inboundCallRoute is set to PH. When I call our number it shows up in Freeswitch, and the phone rings. But when I pick up the line it is silent for 2 seconds then I get a dialtone, and the inbound call is still ringing. Not quite sure where I am missing on this but any help would be appreciated. Ultimately what we would like to do is record all inbound and outbound calls to our office.
Thank you,
Geoff
QBZappy:
v.2geofs,
Welcome.
I have a feeling that we can expect a "Freeswitch How To" very soon. There isn't much, if any documented use with Freeswitch. :D
v.2geofs:
I've discovered that. Have you any idea why my bridged call is not picking up?
QBZappy:
v.2geofs,
I don't have any experience with Freeswitch. However that won't stop me from commenting. :D
Perhaps if you set the OBi as an extension off the pbx using one of the sip accts (not using VG), you might find it easier to set up. Routing can then be done using sip uri ex: SPX(100@freeswitch_ip:port).
v.2geofs:
What I have done is set SP1 and SP2 to be unique extensions on Freeswitch (1001 and 1002). Then I configured VG1 to go to the Freeswitch IP as 1003. I routed all LN1 calls to vg1($1), and all SP2 inbound calls to PH, and all Sp1 inbound calls to aa.
Then in freeswitch I bridged 1003 to 1002 and I bridged 1002 to 1001. This allows me to record all inbound calls in freeswitch (destination_number=1002) and all outbound calls (destination_number=1001). The downside so far is that I can only dial out using the AA as I have not yet figured out how to forward the number to be called through freeswitch and acquire them on the OBI side. Once I can do that then I will change my SP1 call route to LN1.
Right now I am working on programming freeswitch to navigate the AA, unless the is another method to do that. Going to try vg3 for that and see what happens.
Thanks for the suggestions.
Geoff
Navigation
[0] Message Index
[#] Next page