Incoming voip.ms calls not ringing
infin8loop:
Quote from: QBZappy on December 20, 2012, 08:04:05 pm
⚓ :D
I laughed my ASCII off but then I googled and discovered it was unicode. My cluelessness is expanding faster than the universe.
d_source:
What lights should be on when the OBI110 is in use? I have voip only, no POTS line attached to the device.
d_source:
It seems like my device is rejecting calls. Trace is below and it's giving a "Busy Here Message". Can anyone help? I have no clue what to do here.
|Time | 68.233.226.97 |
| | | myIP |
|16.195 | INVITE SDP (g711U g729 telephone-eventRTPType-...) |SIP From: "VoIP.ms" <sip:5149089725@68.233.226.97 To:<sip:acct@myIP:5060
| |(5060) ------------------> (5060) |
|16.257 | 486 Busy Here |SIP Status
| |(5060) <------------------ (5060) |
|16.258 | ACK | |SIP Request
| |(5060) ------------------> (5060) |
obi-support2:
You might have DND (Do Not Disturb) enabled (perhaps by accident dialed the * code). Check under CallingFeatures on your SPx config for that option.
Otherwise, your SPx Service's InboundCallRoute is not routing the call to ring the call. Worth a check there also.
Thank you.
d_source:
Under SP1 Service: X_InboundCallRoute is set to ph.
Under calling features: DoNotDisturbEnable is unchecked (which i would assume means it's not enabled).
Are these the two I was supposed to check?
I installed and registered a softphone and tried calling my DID and the call went trough to the softphone, so now i'm pretty sure the problem is with the device itself. Any other suggestions?
THX
Navigation
[0] Message Index
[#] Next page
[*] Previous page