PSTN bridging between 2 OBI

<< < (2/2)

ianobi:
Everything looks like it is in place for this to work. Please recheck through my suggested settings. Both Phone Port PrimaryLines should be PSTN. Check the changed DigitMap, make sure no white spaces have got in by mistake etc.

In the house OBi this rule should be routing the calls to PSTN:
{("softphonenumber"|"secondOBInumber"))>(xx.):LI}

Instead, it looks like this rule is being used:
{(softphonenumber"|"secondOBInumber"):aa}

That would indicate that no digits have been received at the house OBi.

In the “secondary” OBi is this at default?:
Physical Interfaces -> LINE Port -> DigitMap:
(xxxxxxxS4|1xxxxxxxxxx|xx.)
It’s not a great DigitMap, but at least the xx. rule should accept any digits dialled.

ianobi:
Another check is to dial 5141234567 from the “secondary” OBi. While that call is still ongoing, log into the OBi portal expert pages for the “secondary OBi”. Look at Status > Call Status. Under Phone1 and OBiTALK1 the Peer Number should show 3*5141234567

Clobee:
Hi,

All the config was ok.  I factory default both unit to try from scratch.  And It's working now. :) 

Thank you for your help!!!

Navigation

[0] Message Index

[*] Previous page