Hong Kong and China OBi Users Group （中港OBi用家论坛）
chuliu:
hi I am in hk and got an obi 110.
I set up sip1 to use 2b no and sip2 to iptel sip no.
When I dial in to the 2b no, I hear aa but whenI press 1, there is no response.
I tried to dial using obitalk iphone app, and then I hear aa and it works if I press 1 or 2 or 3. What is wrong?
yhfung:
Please note the caller ID (incoming telephone number) has been registered as a member of circle of trust (COT). If you did, your DTMF signals were not detected by your OBi110. please register another hardware phone to test it.
YH
Kaizer:
going to HK this summer. plan to setup obi with GV on sp1 and sp2 in the US prior to flying out. once i get to hotel in HK is it as simply as connecting the obi to the hotel's wired LAN port, add in a telephone and I can receive the US calls and make US calls (via GV)?
yhfung:
It should be the same as you did when you were in the US provided the hotel does not block the VoIP packets (in most cases, it would not). I believe that the telephone set used in hotel could be used.
YH
HHforOBI:
Does anyone successfully connect OBI from mainland China?
I have one unit in China which just couldn't connect to Internet. the internet connect has been tested fine, and the unit itself has pre-configured in US with Google Voice, should I have it to be factory reset in China, and re-register? please advice
Navigation
[0] Message Index
[#] Next page
[*] Previous page