caller ID visible in line status but no caller ID in peer number field

<< < (2/2)

ianobi:
Seems odd. If the SIP signalling works to set up the call, then I'm guessing it should work when the SPA sends the "bye" signal to the OBi.

I would try to eliminate the GSM device or the SPA from the setup and see if the problem goes away. Any chance of setting up an incoming call from sp1 on the OBi and forwarding it to the SPA, then seeing how call clearing works? To eliminate the SPA you might set up a softphone on a PC/laptop with the same settings and forward an incoming call via the GSM device to it. Phonerlite is free and has a good debugging feature to trace back through SIP messages.

sambgp:
Yes its very odd and frustrating, inspite of having the caller-ID info available i cant forward it to the VoIP side unless i use an ITSP because of this disconnection problem.

I tried forwarding calls from SP1(which is registered with betamax) to the SPA instead of SP2 but the problem persists, the moment i use direct calling with URI's it stops disconnecting from the VoIP side.

Will try to eliminate the GSM device as you have suggested and connect the obi to my landline to see if the problem goes away. If nothing works out will have to resort to debugging, will keep this thread updated.

Navigation

[0] Message Index

[*] Previous page