OBiTALK is not saving in the Expert Configuration

<< < (2/2)

Rick:
I don't use either interface, I go directly via IP and all my changes take.  Saw no reason to use those ways in with direct IP access available.  Then again, I don't do fancy things with my OBi, just use it for GV.

Felix:
Daniel,

What you are describing should work... so it's probably a support issue (that is, something specific to your unit). One thing to note, though. I doubt that the updates are controlled by OBiTALK provisioning setting. I have Interval set at 86400 (which I think is the default); however, any changes I make on the portal are pushed to the device within less than a minute.

That said, I don't see any other setting that would be more applicable - so I may be completely wrong :)

danwong:
Just tried again (after a year), and now the saving now works properly.

Mike1:
I know it's 3 years since this thread was last touched but I just had to troubleshoot this so I'll post my solution in case any others stumble across this as well.

Trying to save changes to ChannelTxGain and ChannelRxGain by navigating directly to the device's IP address does not save the changes.  For these 2 fields, you must change these two fields via the obitalk.com portal under Obi Expert Configuration -> Physical Interfaces -> PHONE X

Changing there will save the new values to the device.

drgeoff:
Quote from: Mike1 on May 05, 2017, 12:44:16 pm

I know it's 3 years since this thread was last touched but I just had to troubleshoot this so I'll post my solution in case any others stumble across this as well.

Trying to save changes to ChannelTxGain and ChannelRxGain by navigating directly to the device's IP address does not save the changes.  For these 2 fields, you must change these two fields via the obitalk.com portal under Obi Expert Configuration -> Physical Interfaces -> PHONE X

Changing there will save the new values to the device.

@Mike1

You need to read and understand http://www.obitalk.com/forum/index.php?topic=61.0 before doing any more troubleshooting on OBis or posting about configuring them.

Navigation

[0] Message Index

[*] Previous page