**2 Dialing delay when calling on SP2

(1/2) > >>

M105:
I did some searching on the forum and didn't find and answer so I'll ask.  If it has already been answered someone please point me at it.  :)

I have my old Gizmo5 SIP account set up in ProfileB and SP2.  Everything works fine and I can make a call by dialing **2 and the munber.  When I do this, I experience a 20-30 second delay before the call connects.  I figure someday soon when Gizmo dies I may want to set up another SIP account for SP2 and would like to debug the delay problem.

I know this is not a Gizmo problem as it works fine and fast on my old PAP2.

Any idea what the problem is?

AmigaDude:
Not sure why, but you might want to try dialing a pound sign # after the last digit.  I think this tells the Obi that you are done, and any delay from that point forward should be downstream.

RonR:
FWIW, I just configured SP2/ITSPB for my Gizmo5 account and there's no appreciable delay after dialing (with a 10/11 digit number and without any trailing '#' being entered).

My ITSPB DigitMap is:

Code:

(1xxxxxxxxxxS4|<1>[2-9]xxxxxxxxxS4|<1870>xxxxxxxS4|011xx.|xx.|(Mipd)|[^*]@@.)

M105:
I tried it with and without the # and saw no difference.  I also went back to the default DigitMaps everywhere and saw no difference.  It works, it just takes 30 seconds or more to dial.

Hmmm.

M105:
FWIW:  I have Obi installed on my Android phone.  If I dial **9 and my Obi number it immediately connects to the Android.

Interesting that only **2 seems to be giving the delay.   Also, I am running the default outbound digitmap.

Navigation

[0] Message Index

[#] Next page