Obi110 and MyNetFone Australia problems

(1/5) > >>

JohnGee:
UPDATE a week later = Working. It was the restrictive ADSL Modem.
--------------------------------------------------------

I cannot get my Obi110 to work fully with a VoIP provider.

The Voip is  mynetfone.com.au  (MNF)
The sip domain is:     sip00.mynetfone.com.au

I have worked extensively with the config settings both through Obitalk  and through the device's local IP using my browser.

I have a DID with MNF and it works fine on the Obi110 for incoming calls.

However, I cannot get any outward calls to work.

The device shows it is registered when using the Obitalk interface.
I have tried many Dial Plans that should work OK. from (x.)  to
(*xx.|000S0|121S0|151S0|181S0|[2-9]xxxxxxxS0|0[23478]xxxxxxxxS0|0011xxx.|1800xxxxxxS0|1300xxxxxxS0|13[1-9]xxxS0|xxx.)

The calls are simply not getting to MNF.

I am not using the Obi110 phone line, just the sp1 line.

I am able to make outward calls with my MNF configured in my PC's softphone. That al works great, so I must have something wrong at the OBI end.

Any clues?

Thanks

carl:
I hope that someone here picks up here who can provide you a real help but what I can see is not a proper digitmap for Obi.

QBZappy:
Quote from: JohnGee on January 31, 2013, 08:31:09 pm

I cannot get my Obi110 to work fully with a VoIP provider.

The Voip is  mynetfone.com.au  (MNF)
The sip domain is:     sip00.mynetfone.com.au

I have worked extensively with the config settings both through Obitalk  and through the device's local IP using my browser.

I have a DID with MNF and it works fine on the Obi110 for incoming calls.

However, I cannot get any outward calls to work.

The device shows it is registered when using the Obitalk interface.
I have tried many Dial Plans that should work OK. from (x.)  to
(*xx.|000S0|121S0|151S0|181S0|[2-9]xxxxxxxS0|0[23478]xxxxxxxxS0|0011xxx.|1800xxxxxxS0|1300xxxxxxS0|13[1-9]xxxS0|xxx.)

I am not using the Obi110 phone line, just the sp1 line.


*xx. = not proper syntax I think. 'xx.' is the default that will dial anything after a pause of a few seconds.

Since you use SP1 for calling, you should setup SP1 as the primary line.
EX: Phone PrimaryLine = SP1 Service

This should do the trick. You may need to work on the digit map to fine tune it to your location. I believe that this has been setup by previous forum participants. You may want to do a search on the topic.

This site might interest you. You will find people from your neck of the woods:
http://forums.whirlpool.net.au/

QBZappy:
JohnGee,

Here you go. This may save you some time.

OBi Down Under: Australia OBi100 and OBi110 Config / Set-up
http://www.obitalk.com/forum/index.php?topic=616.0   

JohnGee:
@QBZappy

Thanks a bunch. I'll use that info and see how I go.

I have 3 Obis, and they all work well apart from this one with MNF. Hopefully yuor tips will help. :-)

Thanks again

JohnGee

Navigation

[0] Message Index

[#] Next page