Automatic switch between trunks when one becomes unavailable

<< < (3/6) > >>

ianobi:
We really need to see Status > Call History after a call has failed. This can only be seen in your OBi web page. Dial ***1 to get the ip address, put that in your browser. To log in the User Name and password will be "admin".

Call History cannot be seen in the OBi Expert Configuration pages.

hwittenb:
xibai,

Although it looks to me like the Trunk approach should work, CallWithUs does not require registration to make an outgoing call.  You can have the SP2 setup to not register and still make calls with CallWithUs over SP2.  The OBi will show an SP2 status of Registration Not Required.  If you do not have incoming calls from a DID with CallWithUs I would try that setting (X_RegisterEnable unchecked). 

Maybe the problem has only to do with the Registration sip sequence failing.  It doesn't make sense that you could make calls with a PAP2 and not the OBi when both are behind the same router unless it has something to do with the sip Registration itself.

ianobi:
hwittenb,

Thanks for the useful info. I agree the best approach is to fix the problem with callwithus in the OBi.

Looks like it is going to be difficult to make sp2 "fail" in these circumstances.

xibai:
thanks you guys,

Here is what I got from the web:

Terminal ID        Phone1                                         SP2
Peer Number      **21(plus ten digits local number)     the ten digits local number
Direction            Outbound                                     Outbound
                                                                          End call (407 proxy authentication required)

to hwittenb, the reason I can not make call through sp2 is because I Intentionally make the registration by putting a wrong password so that I can test the autonomic switch from sp2 to LINE. But hwittenb helps me since I can disable the registration so that incoming calls only routes to PAP2 then to Obi11o LINE to avoid conflict.

By the way, <**2>86x. is better put under the SP1 or phone port? Putting into phone port may be more logoic?

ianobi:
As you can see your call went to callwithus on sp2 and then failed due to wrong password. I cannot see a way to make the OBi110 see this route as failed, maybe hwittenb can suggest a way forward.

<**2>86x. is in the correct place. By putting it in your PrimaryLine DigitMap you achieve automatic routing of calls to sp2.

Navigation

[0] Message Index

[#] Next page

[*] Previous page