instructions for GV911 on OBI202?

(1/1)

TerriP:
Does anyone have the instructions for GV911 on OBi202 - they say it works with OBI202 but they only provide instructions for OBI100 & 110.  I am assuming instructions for 202 are different? Don't see them anywhere; I've emailed gv911 but have not received a reply?

Thank you,

lhm.:
“ITSP Profile A (and/or B, C or D) General” which is located under Service
Providers

Digit Map and enter the following in the Digit Map
(<911:14242798234>S0|<922:14242798235>S0|1xxxxxxxxxx|<1>[2-9]xxxxxxxxx|
011xx.|xx.|(Mipd)|[^*#]@@.)


Test by calling 922 for database confirmation.
You should also call your local non-emergency dispatch center and arrange for an actual 911 call test.

Additionally, smart911.com is a great asset if available in your area.

TerriP:
 

Unfortunately smart911 is not available in my area. -

After inputting the digit map above - when I dial 922,  I get a busy signal?

Just to clarify the digitmap above is the same as what is given for OBI100 and I have the OBI202.  So both devices should use the same digitmap for gv911?

Thank you.


 

lhm.:
Yes it should be the same.

Make sure you are using a zero and not an O at the end of string <922:14242798235>S0 as O will cause a busy signal.

TerriP:
Thank you ... It was that I checked the obitalk box when I was done - didn't realize I was supposed to leave that unchecked - it's all good and working now!
Thank you again,


Now if I could just get the wifi dongle to work!  ::)
Terri.

Navigation

[0] Message Index