Just installed my first obi device obi202 have questions....Help
Hoosier:
ok got line 2 working however the ringtone is different, may be my phone causing that? now what do i do to set set anveo for 911 calls just to line 1?
Thanks for your help QBZappy.
MikeHObi:
Quote from: Hoosier on February 08, 2013, 09:12:08 am
ok got line 2 working however the ringtone is different, may be my phone causing that? now what do i do to set set anveo for 911 calls just to line 1?
Thanks for your help QBZappy.
Why would you want emergency calls to only be routed if you have picked up line 1 and dial 911? If you dial 911 on line 2 you just want to be out of luck?
Each line in the obi by default gets a different ringer behavior. Ring 1 is usually on sp1, ring 2 on sp2 (X_DefaultRing) based on the Ring Profile (X_RingProfile) typically "A".
With a 202, you setup Anveo on SP3 and check the box to "Use This Service for Emergency 911 Calls". By default all configured SP channels will be set to use SP3 for 911. You must configure Anveo to have E911 active on your account.
Hoosier:
MikeHObi, sorry did not mean to sound as if i wanted line one only to dial E911. I just assumed you would have to setup an Anveo account for each line. Its good to know that one Anveo account will work with both lines.
Can you change the ring tones? Can sp3 or sp4 be set to use with line 2 rather than sp2? Not that that i would do that bur just curious. I assume sp3 and sp4 have different ring tones then sp1 or sp2? Thanks
Rick:
Every line here a different ring tone. Go into setup and you can change any of them.
MikeHObi:
Quote from: Hoosier on February 08, 2013, 05:32:59 pm
Can you change the ring tones? Can sp3 or sp4 be set to use with line 2 rather than sp2? Not that that i would do that bur just curious. I assume sp3 and sp4 have different ring tones then sp1 or sp2? Thanks
All services can have different ring patterns assigned to them, as well as all services could have the same ring pattern assigned to them. It is configurable in the expert config on obi-talk or through the local webpage on the obi.
Navigation
[0] Message Index
[#] Next page
[*] Previous page