New to OBI - Installed OBI100, bad quality call & constant ring

(1/2) > >>

rcrivera:
Hello All,

Im new to OBI and just installed OBI100 to use with GV.  Call quality is good when calling out but quality on incoming calls are bad.  Callers either say that sound is broken up or I sound like a robot.  I occasionally will also get a constant ring on incoming calls (solid non-stop ring instead of normal ring sequence).  After searching the forums I found that interference and bypassing the wifi router might eb the solution but its still happening.  I also updated the device to the latest firmware.

Any info is appreciated.

Thanks-

lhm.:
Try this,

Switching your OBi's Ethernet ports to 100 mb/s full duplex:

1. Dial *** (wait for response) then press 0
2. Enter option 27 and press #
3. Press 1 to set a new value
4. Enter a value of 1 and press #
5. Press 1 to confirm/save
6. Hang up
7. Wait for the OBi to reboot

rcrivera:
Sorry - I forgot to add that too.  I switched to Full Duplex last week and still having problems.  I tried a few tests today and I can hear a caller fine on my end but the other line says that my sound is broken up.

Any other thoughts?

RC

rcrivera:
Would ISP speeds have any impact on quality?  I have 10mbps down / 2mbps up roughly (comcast business)

QBZappy:
More than enough:
http://www.connect802.com/voip_bandwidth.php?codec=G711&samPeriod=20&samPerPkt=1&rtp_compression=no&vad_active=no&standard=802.11g&Submit=Calculate

Navigation

[0] Message Index

[#] Next page