Setting SP 2 as the primary dial out/ring in line

<< < (2/2)

azrobert:
Quote from: bigbear216 on February 28, 2013, 03:03:31 pm

I have now tried accessing these settings in both the web interface (192.168.....) and also on the website. On the web interface it will allow me to change the primary line to SP2, but when I go to reboot and then look at the settings again, they have re-defaulted to SP1. It makes me want to just reset all of everything and start all over again. something isn't working right.


If you want to update your OBi using the web interface change the following:

System Management/Auto Provisioning/OBiTalk Provisioning/Method=Disabled

Now OBiTalk will not override your changes made from the web.

After this change you CANNOT make configuration changes via OBiTalk.
You can only use one method.

See: http://www.obitalk.com/forum/index.php?topic=61.msg109#msg109

Navigation

[0] Message Index

[*] Previous page