Prevent incoming SIP calls
Nepto:
Quote
@ QBZappy
Quote
SPX Service->X_InboundCallRoute = remove the "ph"
If there are no other rules and you leave this blank, then the OBi assumes ph as a default position. To stop the phone ringing we need our old friends the curly braces {}.
This seems to work well, but only for few seconds. Then configuration changes are reverted back. Here is what is happening:
I go to SP2 Service->X_InboundCallRoute administration, and change "ph" to "{}".
Save the changes. Reboot is required.
So I do reboot and I can see the red-light for a while.
After reboot is done, I can see that "{}" is saved.
If I make a call right now, it will be answered with busy signal. Great!
Then suddenly, after following 15-20 seconds, red-light will flash again and Obi is rebooted again (without my interaction). I do not mind, it can reboot 100 times a day. Problem is, that settings are reverted back, so there is no longer "{}" in SP2 Service->X_InboundCallRoute, but there is "ph" again. Of course I can call to my Obi and it is ringing.
I tried it 30 times without no luck. Second reboot just happen, no matter what I do. It is so frustrating. I would never believe, that something like this (block incoming calls) could be that difficult.
Any ideas?
ianobi:
Nepto - welcome to the forum.
Your problem is as old as the invention of the OBi :) Your settings are being overwritten by the OBiTALK portal. Read here:
http://www.obitalk.com/forum/index.php?topic=92.0
Until you are familiar with all of the pros and cons of provisioning etc, I recommend you go with the preferred Obihai method:
Make changes via the Obi Expert Configuration pages. From your OBi Dashboard, click on your OBi number and follow the prompts to get there. To change a value uncheck both boxes to the right of the value and leave them unchecked. After changing the values on one page, press submit at the bottom of the page and wait a few minutes for the Obi to reboot. Then move on to the next page if required.
mykmayk:
Quote from: QBZappy on February 27, 2013, 07:50:54 am
Another way to do it:
SPX Service->X_InboundCallRoute = remove the "ph"
Very helpful tip. In my case, I need this because I have incoming calls forwarded to both LINE and SP2. I want the incoming call to ring either the LINE OR SP2 ONLY but NOT both simultaneously.
Danke!
Navigation
[0] Message Index
[*] Previous page