Sending "sip:" prefix with the number

<< < (2/2)

azrobert:
ianobi,
Please read my reply#1.
The transformation is correct, but the provider never received the call. I tried it with another provider and it also didn't receive the call. I don't know if it's my providers or the OBi that's at fault.

ianobi:
azrobert,
This looks like you are calling an internal ip address on your own network:

Phone1 call history shows:
123*192*168*1*100

SP2 call history shows:
sip:123@192.168.1.100

The test needs to be made to the external address of your voip provider.

Felix:
Thank you so much!

First, I realized that I goofed... I put the rule in the wrong place - In Phone OutboundCallRoute instead of Profile DigitMap. So, azrobert correctly noted, sip: was appended and no longer managed SP1 Digitmap.

Once I put {(Mipd):sp1} in Phone, and <:sip:>(Mipd) in Profile DigitMap, I see Code:

To SP1(sip:987654@10.20.30.40)

- just what I expect. Unfortunately, I get 404 from provider; but obviously, this is not OBI issue any more. I'll try a few other things and report the results

Felix:
Turns out that Voipo doesn't support sip addresses coming from devices. The only way to make a SIP call is to set up speed dial (Voipo calls them "outbound routing") on their portal.

Navigation

[0] Message Index

[*] Previous page