OBi 110 Ehternet Port Running Slow
bsdaiwa:
Would anyone have an idea why the Ethernet port on my OBi would be running at 10M Half? My router, which the OBi is directly connected to, reports that the port is not operating at 100M Full. I moved the device to other ports on the router and each of the other ports went from 100M Full to 10M Half as soon as the OBi was attached.
I don’t see anywhere in the OBi setup that allows you to configure the Ethernet port.
Anyone have any ideas?
Thanks
Rick:
Posted many times. It comes that way. You can change it easily.
Switching your OBi's Ethernet ports to 100 mb/s full duplex:
1. Dial *** 0
2. Enter option 27 and press #
3. Press 1 to set a new value
4. Enter a value of 1 and press #
5. Press 1 to confirm/save
6. Hang up
7. Wait for the OBi to reboot
Confirm settings:
Quote
How to verify the current setting of the OBi's ethernet ports 10 or 100 mb/s full duplex:
1. Dial *** 0
2. Enter option 27 and press #
At this point the OBiMAN will read back the current value:
0= 10 mb/s
1= 100 mb/s
bsdaiwa:
Thanks, is there also a way to change the duplex to full or does this command do both?
Rick:
Quote from: bsdaiwa on March 09, 2013, 12:30:15 pm
Thanks, is there also a way to change the duplex to full or does this command do both?
That's the ONLY thing it does do...Switching your OBi's Ethernet ports to 100 mb/s full duplex
bsdaiwa:
Got it, and thanks. The port on the router now shows 100M Full.
Thanks again.
Navigation
[0] Message Index
[#] Next page