Problem forwarding busy calls from {ph1} to ph2 Obi202
PlummerBob:
Obi202. I have call waiting disabled on ph1, and have SP1 setup to forward to ph2 on busy. I can't seem to get ph2 to ring under these circumstances. I had this exact setup working for 2 months, and then it suddenly stopped working, or maybe I just noticed it. But I am sure at one point it was working. I have X_InboundCallRoute set as "{ph1}" and CallForwardOnBusyNumber set as "ph2". CallForwardOnBusyEnable is enabled. CallWaitingEnable is disabled/unchecked. I have also tried disabling CallWaitingCallerIDEnable.
What this setup was doing, was make it so if ph1 was in use, all incoming calls would just forward and ring to ph2.
Any help troubleshooting would be appreciated.
Thank you.
PlummerBob:
I have a suspicion that this could be related to the firmware version I have 3.0.1 (Build: 3741), because in the past I had this forwarding setup and there were no issues.
Does anyone have copies or links to other versions of firmware that I could try out?
InetUser:
http://www.obihai.com/firmware/OBi202-3-0-1-3741.fw
QBZappy:
Ron,
He mentions that he is already using that version (Build: 3741). He would like a previous version. Do you keep copies?
Quote from: PlummerBob on March 21, 2013, 01:55:14 pm
I have a suspicion that this could be related to the firmware version I have 3.0.1 (Build: 3741), because in the past I had this forwarding setup and there were no issues.
Does anyone have copies or links to other versions of firmware that I could try out?
Ostracus:
http://www.obihai.com/firmware/OBi202-3-0-1-3722.fw
Navigation
[0] Message Index
[#] Next page