Obi110 and Obi202 on same network.
Felix:
Quote from: VOIPisGreat on April 12, 2013, 04:22:50 pm
Can you use just one phone port to access both devices?
For example, having the phone connected to just the obi202, can I make and receive calls from the obi110?
No.
You are probably thinking about a softphone or IP phone where you specify IP address of PBX; so even if you have 2 PBX on the network, you can (theoretically, at least) connect to either one, or even both. Well, analog phone doesn't have such capabilities; it's calling over the device to which it is plugged in.
ianobi:
If you have at least one spX configured for SIP on both devices, then a simplified version of this could work for you:
http://www.obitalk.com/forum/index.php?topic=2454.msg15851#msg15851
That deals with calling outbound. Calls coming inbound (say to the OBi110) could be diverted to the OBi202 using the InboundCallRoutes of the OBi110.
The detailed configuration would depend on your existing configurations and knowing Primary Lines etc. I would recommend having the 911 service on the device that you have the phone plugged into.
VOIPisGreat:
Quote from: ianobi on April 13, 2013, 07:22:28 am
If you have at least one spX configured for SIP on both devices, then a simplified version of this could work for you:
http://www.obitalk.com/forum/index.php?topic=2454.msg15851#msg15851
That deals with calling outbound. Calls coming inbound (say to the OBi110) could be diverted to the OBi202 using the InboundCallRoutes of the OBi110.
The detailed configuration would depend on your existing configurations and knowing Primary Lines etc. I would recommend having the 911 service on the device that you have the phone plugged into.
This looks like what I am looking for. Seems a little involved to set it up tho. I'll try to dive into it. Thanks!!!
InetUser:
Quote from: VOIPisGreat on April 15, 2013, 11:27:28 am
This looks like what I am looking for. Seems a little involved to set it up tho. I'll try to dive into it. Thanks!!!
This utility will generate the necessary configuration for Single Stage Dialing using either OBiTalk or SIP for you:
http://www.dslreports.com/forum/r28046615-Configuration-Utility-for-OBi100-110-202
azrobert:
This doesn't have to be complicated.
I use a Voice Gateway to access a 2nd OBi.
On 1st OBi
VG2 Setup
AccessNumber: sp2(192.168.1.30:5062) (address of 2nd OBi)
DigitMap: (6xxxxxxxxxx)
AuthUserID: robert
Phone Port Digit Map
Add after beginning parenthesis: (Mvg2)|
Phone Port OutBoundCallRoute
Add to the beginning: {(<6:>xxxxxxxxxx):vg2},
On 2nd OBi
SP2 service
X_inboundCallRoute Add to the beginning: {(robert)>(xxxxxxxxxx):sp1},
X_UserAgentPort: 5062
ITSP B -> SIP
X_DiscoverPublicAddress: unchecked (this fixes audio problems)
Dial 68005551212 on 1st OBi and 8005551212 will go out SP1 on 2nd OBi.
Edit:
The above assumes SP2 is setup as SIP on both OBi's.
Navigation
[0] Message Index
[#] Next page
[*] Previous page