Quote from: aknisley on April 07, 2013, 07:05:50 AM
I can make calls out from the phone connected to the OBi100 but when I call the POTS phone number, the Phone attached to the OBi100 does not ring. Neither log shows inbound call.
The incoming PSTN Line call first comes to the LINE Port on the OBi110. The InboundCallRoute sends it to the distant OBi using some sip settings and code setup under SP1. To troubleshoot the problem I would check the basics.
1. While the phone is ringing log into your OBi110 and look at Status-->PHONE & LINE Status. The screen that comes up should show Line Port Status "Ringing". If it doesn't then maybe the OBi has problems detecting the ringing on the line. There are some settings for that under RingDetection on the Line Port.
2. If it shows ringing then you could perhaps change the Inbound Routing to ring a phone connected to the OBi110. You would change the InboundCallRoute on the Line Port from SP1(ip_address:5100) to ph
3. If that works change the InboundCallRoute back to the SP1 forwarding address. Check the Status of SP1 under Status-->SystemStatus. It should say "Registration Not Required".
4. If that works verify that you have the correct ip address and the correct sip port number.
5. If that works maybe you network router is blocking incoming calls going to the OBi100 because it didn't first initiate an outgoing request. Forward the OBi100's sip port in your router to the OBi100. With direct ip calling, the forwarding is required when the call is coming from outside the local network but often is not when it is within the local network but that depends on your router's firewall.