Can't connect my IP Phone to my OBi202

<< < (2/3) > >>

Lavarock7:
You should be able to call between subaccounts if each account has an extension assigned to it and they all register to the same server. This should work even without funding.

Also you must make sure that the extension format is allowed in the devices dialing string.

N7AS:
azrobert,
Thanks for the tip.
I got it to work except can'd dile between extensions. When I dial the OBi202 extension (202), I get a busy right away. When I dial the IP phone extension (100), I get a busy after a few seconds. Both the OBi202 and the IP phone registers to PBXes. Should there be an Inbound Route in PBXes?

I changed the extension numbers to 100 for the IP phone and 202 for the OBi. As the OBi202 has no line port, I changed references to li to sp3 (localphone.com).

Incoming calls to SP1 (Google Voice) ring both the phone connected to the OBi202 and the IP phone.

EDIT:
I can now call the IP phone extension (100) by using a speed dial (SP4(100) but when I dial 202 from the IP phone I just get a busy and no ring on the phone connected to the OBi202.

azrobert:
In my example change 99 to 202 in the Sub-pbx dial rules and the PBXes Outbound Route Dial Patterns.

I have a typo in my OBi SP2 X_InboundCallRoute.
Before the {ph} there should be a comma, not a dot.

In my example when the IP phone dials “202”, PBXes should send the “202” to the OBi via the sub-pbx. When the “202” comes thru SP4 there is no match in the X_InboundCallRoute and it will default to the last entry {ph}

You could add this rule:
{(4809999999)>(202):ph}

Edit:
I corrected the typo in the guide.

N7AS:
azrobert,

Thanks, that worked.

Dagwood:
N7AS,

Within the last week I set up my nre Yealink T22P with my OBI202 with accounts from freephoneline.ca (SP1) and voip.ms (SP2) without having to use any pbx stuff.  I have it set up so my IP phone uses the OBI without having to register (through SP3 back to SP1) and also with a sub account directly to voip.ms.  As far as the Yealink having the option to make calls without registration, I think that's enabled automatically and there is no option to turn it on or off.  I did have to update my Yealink phone to the latest software before I was able to get this to work.

If you're interested in more detailed info to try it this way, let me know and I will see what I can dig up in the next few days.  It would take me a bit of time to check all of my settings to see exactly what I changed.

Navigation

[0] Message Index

[#] Next page

[*] Previous page