Outbound International calls via SP2
faris98:
Thanks!
Just got your response while I was typing mine. I will go ahead and try dialing with **2
Here is what I was going to post:
Thanks for all the responses.
The code I added to Phone-> OutBoundCallRoute to route traffic via SP2 is working. I verified using the Obi History
{(011xx.):sp2},{([1-9]x?*(Mpli)):pp},{(<#:>|911):li},{**0:aa},{***:aa2},{(<**1:>(Msp1)):sp1},{(<**2:>(Msp2)):sp2},{(<**8:>(Mli)):li},{(<**9:>(Mpp)):pp},{(Mpli):pli}
But, I'm still getting a voice error that the number I dialed was rejected by service provider 400.
I tried CallWithUS using a Softphone and I'm able to dial just fine using 011
Ideas?
faris98:
Tried dialing with **2011
I'm still getting a voice error that the number I dialed was rejected by service provider 400.
Shale:
Quote from: faris98 on April 13, 2013, 02:50:27 pm
But, I'm still getting a voice error that the number I dialed was rejected by service provider 400.
I tried CallWithUS using a Softphone and I'm able to dial just fine using 011
Ideas?
I suggest you address the questions that azrobert asked about your configuration. Have you made any successful call (such as a domestic call) via CallWithUS? If not, maybe you should try a domestic call through them.
azrobert:
I also have a CallWithUs account and we don't dial the 011 prefix. Apparently the 011 prefix is optional with them.
400 is an SIP error. Here is the description:
400 Bad Request: The request could not be understood due to malformed syntax.
I'm guessing this is not caused by an OBi configuration problem.
CallWithUs recommends turning off SIP ALG on the router and SIP ALG can cause strange things.
I don't have SIP ALG option on my router, so I can't tell you where to find it.
If that doesn't work I would open a Request Support with OBihai, unless somebody else can help you.
faris98:
SOLVED!!!!! ;D ;D ;D ;D
You were right on! I had to Disable SIP ALG on my router
Many thanks!
Navigation
[0] Message Index
[*] Previous page