Problems with DTMF tones
zoomin:
Quote from: RonR on June 04, 2011, 04:39:33 pm
Quote from: zoomin on June 04, 2011, 04:36:23 pm
Any way to make DTMF tones longer? They seem to be too short compared to what my phone is putting out.
Physical Interfaces -> Line Port -> DialDigitOnTime
Great! And you know what? It actually did the trick!
I set DialDigitOnTime to 300 (was 200), and DialDigitOffTime to 50 (was 200).
Did 5 calls and all 5 went through fine!
So, if anyone else is having similar issue, I strongly recommend playing with these values. :)
Thanks, RonR!
Dale:
same problem here using GV.
I found that if i held down the numbers for longer it would work. I looked in vain for DialDigitOffTime in the Phone settings for an Obi100 but could not find that parameter.
Changed
Physical Interfaces -> PHONE -> PortDTMFRxMode to Software
an intitial test seemed better but the Rx suggests this is to do with receiving...
Now trying Service Providers > ITSP Profile X > General > DTMFMethod = InBand
Dale:
it helped, but again today I had to hold down the keys longer to get them to work...
is there a DialDigitOnTime setting for the PHONE port? (i cant see it)
ShermanObi:
@Dale
A software update may be the remedy.
Please dial ***6 from the phone attached to your OBi.
If there is a software update, press 1 and hand-up.
Your OBi will automatically download the latest firmware and restart.
This usually takes no more than 2 minutes.
Dale:
all my obi boxes are fully up to date.
Navigation
[0] Message Index
[#] Next page
[*] Previous page