News:

On Tuesday September 6th the forum will be down for maintenance from 9:30 PM to 11:59 PM PDT

Main Menu

Home to Office Extention - Dial Tone Only

Started by DaveP, April 06, 2011, 08:18:37 AM

Previous topic - Next topic

DaveP

I went through the "Home to Office Phone System Extension Wizard:" and setup my 2 devices while both were connected to the same LAN. I used an outside FAX line to test and everything worked as expected. I could dial out using the Obi110 and receive calls in at the remote Obi110.
I then moved the `office' Obi110 to an analog line off my Toshiba phone system.
If I dial that analog extension from another phone it rings to the remote extension and work fine!
When I pickup the handset at the remote extension there is a brief ring and then I am connected to the office Obi but when I try to dial out the tones are not recognized and I continue to get just a dial tone.


I did run the firmware update and Hardware version shows 2.8 and software shows 1.2.0 (Build: 2102)

Can anyone offer any suggestions on how to fix this?