Obi100 Problem DHCP & Static IP Logon

<< < (2/2)

RonR:
It appears you were successful getting an IP address from your modem.  That would seem to confirm there is an ethernet problem/incompatibility between the OBi and your LAN.  Could you perform an echo test with the OBi connected directly to modem?: **9 222 222 222

Are you plugging the OBi into an ethernet switch?  If so, have you tried connecting it directly to one of the router ports instead?

lhm.:
Yes, tried in router port earlier, now connected via hub connected to router switch. Will try the echo test from cmodem. If that is successful should I go forward with firmware upgrade? Also are there ports I should trigger for the Obi?

RonR:
There shouldn't be any problem running the OBi connected directly to your modem, other than you can't access it from your PC.  If the echo test works properly, you should be able to update the OBi's firmware by dialing ***6 on the OBi's phone.

lhm.:
After logging in/registering device with **x xxxx from cable modem Obi I was able reconnect through the router port/switch, and updated firmware from ObiTalk site and switched everthing back to static ips in Obi browser/lan connection.

Bottom line is connection setup of OBi w/static ip and a hub is not possible, at least for my lan.

Thanks for your help.

Navigation

[0] Message Index

[*] Previous page