Caller ID based Distinctive Ring

(1/6) > >>

shadow700:
The feature I am looking for is the ability to have the endpoint device assign a ring based on Caller ID.

The device supports provider specified Distinctive Ring ("Alert-Info"), but not many providers offer this service.

Ideally, this would be accomplished by assigning Caller ID patterns to specific Ring Patterns:

8005551212 -> Ring Pattern 2
8005551313 -> Ring Pattern 3
...

and any limit on the number of numbers entered would be large (50 or more).

Thanks!

QBZappy:
shadow700,

There is a way to send CID to fast busy tone. It is mentioned on the forum. I'm looking over the Ring Profiles. I'm wondering if we can use the same approach to send a number to a different Ring Pattern.

RonR, do you think this can be done?

shadow700:
I put an order in for two 110 units from Amazon today.

I'm hoping there is (or will be) a way to get distinctive ring working.

Is there anything I can do as a user that would get this feature closer to reality?

Thanks!

aberson:
Ancient thread, but... anyone ever figure this out?

I don't see anything about it in the admin guide, but
if it were to ever exist, I would think it would be an argument of the "ph" in the inboundcallroute

something like:

x.1212:ph(2);x.1313:ph(3)

That this is just an idea of how they could implement it; I'm 99% sure it doesn't actually work like that...


Adam

Bob.:
I would also like to know if this is possible.

My Linksys PAP2T did this very easily.  There was an place to enter a series of telephone numbers next to a ring pattern number.  If any of the listed phone numbers showed on the caller ID that ring pattern would ring.

So, my family and friends could have a different ring than everyone else who was calling.

This is a very important feature for me.

Navigation

[0] Message Index

[#] Next page