Local number dialing... One ring then static
Shale:
Quote from: ProfTech on May 30, 2013, 06:05:27 am
You might try setting Physical Interfaces -> Line Port -> DialDelay to 1000 before you contact ObiHai. I fought similar line port issues for a year before someone put me on to this simple change. Cured all of the issues. One of my 110's was exhibiting strange results similar to yours when dialing out. Dead air, static, weird recordings.
Interesting idea. DialDelay is the "Delay in milliseconds before dialing out the first digit to the PSTN line after the OBi takes the LINE port hardware to the Off-Hook state. This is a simple way to allow the PSTN company time to get ready to receive DTMF signals from the OBi without having the OBi monitor dial tone from the PSTN company" The default is 500 milliseconds.
After thinking further, I suspect that is not going to be the cure in this case, because dialing # should still have worked if the problem was not waiting long enough to start dialing. It would not hurt to try the DialDelay first, but I think ianobi's suggestion is probably the way to go.
Lisefd:
Well, I've opened a ticket but haven't had much luck with tech support. They asked VIA email if they could call an 800 number on my PSTN line which I agreed to. After not hearing from the for a couple days, I called Tech Support. The support tech also said he wanted to call an 800 number using my PSTN line and would then reply in an email what he found. Again two days later and still no reply.
Has anyone else had these support troubles?
TIA
orangelau:
I had the same problem before. I reset the "phone" & "line" setting to default, then set it again, everything is Ok after that
Navigation
[0] Message Index
[*] Previous page